Table Saw Stand Safety Instructions - skilsaw SPT99 Instrucciones De Funcionamiento

Read all instructions. Failure
to follow all instructions listed
below may result in serious personal injury.
Fully assemble and tighten all the fasteners
required for this stand. Also remember to oc-
casionally check the stand and make sure it is
still tight. A loose stand is unstable and may shift
in use and cause serious injury.
Turn the tool switch off and disconnect the
power before mounting to the stand. Unin-
tended startup during assembly can cause injury.

Table Saw Stand Safety Instructions

Before operating, make sure that the entire
unit is placed on a solid, flat, level surface.
Serious injury could occur if the tool is unstable
and it tips.
Never stand on the tool or its stand or use it as
a ladder or scaffolding. Serious injury could
occur if the tool is tipped or the cutting tool is acci-
dentally contacted. Do not store materials on or
near the tool such that it is necessary to stand on
the tool or its stand to reach them.
Use only Skilsaw replacement parts. Any others
may create a hazard.
-9-