skilsaw SPT99 Instrucciones De Funcionamiento página 19

Step 3
Assemble H shaped tube to short stand
tube
Place the H shaped tube in the position shown
in figure C so that the holes at the end of the H
shaped tube line up with the holes in the short
stand tube. For each side, insert one 3.5 inch
carriage bolt through the outside of the H
shaped tube. Place a plastic spacer between
the short stand tube and the H shaped tube and
push the bolt through the spacer and the short
stand tube. Place a washer over the threads
and then screw on the nut. Use 1/ 2 inch or ad-
justable wrench to tighten. The nut should be
tight enough so that there are no gaps, but not
so tight as to prevent the bars from rotating. See
Fig. C.
FIG. C
H Shaped
Tube
Short
Stand
Tube
Assembly
Step 4
Assemble Wheels
For each wheel, place the wheel on the shaft
on an H shaped tube. Place a washer over the
thread and screw on a nut. Use 11/16 inch or
adjustable wrench to fully tighten the nut. If the
wheel is difficult to turn, loosen the nut a little.
See Fig. D.
FIG. D
Carriage Bolts,
Spacer, Washer
& Nut
Step 5
Turn table saw over
Lift the H shaped tube until the saw is vertical.
Follow instructions in the Storage, Transporting
& Mounting Section to open or transport the
stand.
-19-
H Shaped Tube
(wheel shaft)
Wheel,
washer & nut