Start Up; Opening Door; Loading - Rautheon UW50PV Manual De Operation

Operation
Start-up
Turn on the main power source (circuit breaker
or cut-off switch on the wall).
When AC power is turned on, the front panel
display will show the program (ROM)
identification code.
This identification code will appear for
approximately five seconds. Then the
computer display will flash "POWER"
and "WAIT" alternately for two minutes.
The display will then show "NEXT00" to
indicate that a cycle can be selected. This
display will be shown at all times that
power is on between cycles, indicating that
the door-unlock solenoid will function if the
door-unlock button is pressed. The machine is
then ready for loading and unloading.

Opening Door

Use left hand to press and hold the door unlock
button located on the lower right front of the
control panel. See Figure 5.
Figure 5
20
Use right hand to turn door handle clockwise
and swing the door left to open. See Figure 6.

Loading

Be careful around the open door,
particularly when loading from a level
below the door. Impact with door edges
can cause personal injury.
Load the washer-extractor to full capacity
whenever possible, but do not exceed the rated
dry-weight capacity of the machine if the
fabric to be washed is quite dense, closely
woven, and heavily soiled. Overloading can
result in an inferior wash. The operator may
need to experiment to determine load size
based on fabric content, soil content, and level
of cleanliness required.
MD003J
Figure 6
CAUTION
MD004J
SW025
F232050