Supply Dispenser; Cycle Selection; Cycle Execution - Rautheon UW50PV Manual De Operation

When loading is complete, ensure that all
fabric is inside the basket. Then close and lock
the door.
Note: When washing items which may
disintegrate or fragment, such as mop heads or
sponges, use laundry nets to prevent drain
blockage.

Supply Dispenser

Dry supplies are placed in the supply dispenser
compartment cups prior to the start of each
cycle.
Liquid supplies can be injected directly into
the supply dispenser by an external chemical
supply system.
Note: Supply dispenser compartment cups
must not be removed when an external
chemical injection supply system is attached to
the washer-extractor.

Cycle Selection

Note: Press keys at their centers just hard
enough to activate them.
Find the cycle number of the desired wash
cycle from the preprogrammed cycle charts in
the Programming section of this manual. Cycle
numbers must be two-digit numbers from
01 to 39.
F232050
Press the numbers desired on the keyboard
and note that these numbers are displayed
after "NEXT."
When keys are pressed on the keyboard, a beep
will be heard. If an error is made, press the
numbers again. As numbers are entered, they
move from right to left on the display.
Note: If the washer-extractor is equipped
with both steam and electric heat, the selector
switch on right side of the control module
must be in the correct position for the desired
heat source, up for steam heat, down for
electric heat.

Cycle Execution

To start the selected cycle, press the Start
key. If the selected cycle number is not in the
computer memory, the display will show
"NCYC." If this happens, select another cycle.
Otherwise, the display will now show the first
step. For example, if the display reads "HL01,"
"HL" represents a hot fill to low level, and
"01" indicates that this is the first step of the
cycle.
As the cycle proceeds, the display will show
the function being executed, the step number,
and the cycle number selected. Pressing the
Edit Cycle key while the cycle is running will
cause the display to show the remaining cycle
time in minutes. Pressing this key again will
return the display to normal.
To begin the cycle at any step other than the
first step, press the Advance key to advance
through the cycle to the desired starting point.
(The Advance key is enabled at the factory
and can be disabled at the laundry site.) Then
press the Start key.
Operation
21