Transferring All Cycles From Computer To Simulator; Transferring One Cycle From Computer To Simulator - Rautheon UW50PV Manual De Operation

Programming
Simulator Operation and Program
Transfer
(Continued)
• If the BALANCE switch is in the up
position during the spin step or drain step
of a cycle, an out-of-balance condition is
indicated to the computer. (See Balance
Detection in the Operation section of this
manual in regard to the drain step.)
The temperature probe (located on the rear
end-panel of the simulator) simulates sump
temperature.
Transferring All Cycles from Computer
to Simulator
All keypad commands will be entered with the
simulator keypad.
Use the following procedure to transfer all
cycles contained in the memory of the
computer to the simulator. (Transferring 39
cycles takes about 6 seconds.)
1. Connect the fiber optic cables between the
simulator and the computer. Verify that the
colored plugs on the ends of the optic
cables match the colors of the ports on the
simulator and on the washer-extractor's
control module (gray to gray, blue to blue).
2. Place both the simulator and the computer
in the PROGRAM mode. The display on
both will read "CYC00."
3. Press the 0 key. The display will read
"WRITE?"
4. Press the 0 key again. The display will
change to "READ?"
5. Press the Enter key. The display will read
"ALL."
58
6. Press the Enter key again. The simulator
display will flash "RECV" and "ALL"
alternately. The computer display will
flash "SEND" and "ALL" alternately.
When the two displays stop flashing, the
transfer is complete.
Transferring One Cycle from Computer
to Simulator
All keypad commands will be entered with the
simulator keypad.
Use the following procedure to transfer one
cycle contained in the memory of the computer
to the simulator. (Transferring 1 cycle takes
less than 1 second.)
1. Connect the fiber optic cables between the
simulator and the computer. Verify that the
colored plugs on the ends of the optic
cables match the colors of the ports on the
simulator and on the washer-extractor's
control module (gray to gray, blue to blue).
2. Place both the simulator and the computer
in the PROGRAM mode. The display on
both will read "CYC00."
3. Press the 0 key. The display will read
"WRITE?"
4. Press the 0 key again. The display will
change to "READ?"
5. Press the Enter key. The display will read
"ALL."
6. Press the 0 key. The display will read
"CYC."
7. Press the Enter key. The display will read
"RCYC00."
Now press the 2-digit code for the desired
cycle number from the computer.
F232050