Rautheon UW50PV Manual De Operation página 43

If clearing the count is not necessary or if
it has just been cleared, press the Enter
key. The computer will now display
"HL0125," indicating the first step of
cycle 25.
6. Press the Advance key to move to the next
step of the cycle.
7. Press key 0 to back up to the previous step.
8. To access further information pertaining to
each step (for example, temperature and/or
time), press the Enter key.
If the display shows a temperature, press
the Enter key again to display the time.
9. Press the Enter key once more to advance
to the next step.
10. At any time, the programmer can put the
program mode switch in the RUN
position, and the computer will return to
normal running mode, provided all
pertinent data for the last step edited
is entered.
11. To change a step within the cycle, press
the Clear key once while the computer is
displaying the step to be edited. Enter the
new step, using the same procedure for
adding a step to a new cycle.
Note: If, after the Clear key is pressed, it is
decided that clearing the step is not desired,
press the Edit Cycle key to restore the step.
(This will work only if a step identification
was displayed before pressing the Clear key.
At other points in the step – such as a time or
temperature display – this restoration effort
will not work.)
F232050
Programming
12. To change the time assigned to a step,
press the Clear key once while the
computer is displaying the unwanted time.
13. To add a step within the cycle, press the
Add Step key. The step will be added into
the cycle after the step presently displayed.
The computer will check to see if enough
cycle memory is left in the cycle to add
a step. (Each cycle may contain up to
51 steps.)
If the cycle memory for this cycle is full,
the computer will display "CYFULL" for
two seconds and return to displaying the
previous step. If the computer sees no
problem, the new step number will be
displayed and the step may be added (as
when adding a step to a new cycle).
Note: Use the following procedure with
caution. It is not reversible.
14. To delete a step within a cycle, press
the Clear key while the computer is
displaying the step to be deleted. Press
the Clear key again: the display will read
"WAIT" while it is deleting the step.
The computer will then display the next
step in the cycle, using the same step
number as the deleted step.
15. If the Add Cycle key is pressed by mistake
instead of the Edit Cycle key when the
cycle number to be edited is entered, the
display will flash "EXISTS" and "EDIT?"
To recover, press the Enter key, and the
computer will change to the edit mode.
41