Zodiac MX 6 Manual Del Propietário página 8

Page 8 |
Zodiac MX6 Pool Cleaner Owner's Manual
ENGLISH ®
™
Operation and Routine Maintenance
The MX6 cycles on/off with the pool filtration pump, vacuuming and cleaning all surfaces randomly throughout
the pool. The climbing ability of the cleaner is dependent on the pool's shape and available water flow. If MX6
is not climbing your walls, ensure the flow is correct by checking the wheel speed and adjust the valves as
necessary. Also, ensure the pool's surface is not covered in algae as a slippery surface will affect the cleaner's
traction.
During each coverage pattern cycle, the cleaner travels forward and pivots. The power scrubber underneath the
cleaner creates downward force for climbing and stability as well as directing debris into the cleaner mouth.
Emptying the Pump Basket
For the MX6 to operate at optimum efficiency, empty the pump basket regularly. The more debris in the pool, the
more often the pump basket should be cleared.
Backwashing the Pool Filter
Always disconnect the MX6 from the pool before cleaning or backwashing the pool filter. After cleaning or
backwashing, let the filtration system run for at least five (5) minutes to flush out the suction lines before
reconnecting the cleaner.
Adding Chemicals to the Pool
Remove the cleaner from the pool for at least four (4) hours when adding chemicals.
Storage and Winterizing
Never store the MX6 in direct sunlight. When storing for the winter, drain out all the water (freeze damage is
not covered by the warranty). Remove all connectors and adapters from the dedicated suction line or skimmer.
When storing the cleaner, even for short times, do not coil the hose as the hose may develop memory which can
affect cleaner performance. Disassemble the hoses and layout flat to store.