Zodiac MX 6 Manual Del Propietário página 9

Removing Trapped Debris from Cleaner
To avoid serious injury, make sure that the cleaner is disconnected from the hose and the pool suction pump
is turned off prior to starting this operation.
1. Press the yellow button on top of the cleaner to release the latch.
2. Open the cleaner lid until it stays open in a vertical position (Figure 10).
3. Look into engine and remove any leaves or debris (Figure 10).
4. If necessary, slowly push engine paddles forward and/or backward to move stuck debris to an accessible
position then remove it. When moving the engine paddles, make sure the cleaner tracks are allowed to move
freely as they will turn as the engine paddles rotate.
5. Close the lid and ensure the latch clicks in place.
Figure 10
6. Turn cleaner over and check for debris in scrubber and inlet (Figure 11).
|
Owner's Manual Zodiac ® MX6
WARNING
Figure 11
ENGLISH
Pool Cleaner
™
Page 9