Troubleshooting - Zodiac MX 6 Manual Del Propietário

Page 10
ENGLISH

Troubleshooting

I f you experience a problem with your MX6, follow the troubleshooting steps below to restore performance. If
further assistance is required, contact Zodiac Technical Support Department at (800) 822-7933.
Please have your serial number and date of purchase available when you call.
Problem
Cleaner does not move or moves slowly.
Cleaner patterns, does not cover entire pool.
Cleaner gets stuck at steps.
Cleaner won't climb walls.
Cleaner riding on its side.
MX6 Spare Parts
Exploded parts diagram and list of spare part numbers is available on the Zodiac website at www.ZodiacPoolSystems.com
and in Canada at www.ZodiacPoolSystems.ca
|
Zodiac MX6 Pool Cleaner Owner's Manual
®
™
Solution
• Confirm that the main drain is closed.
• Backwash the filter and empty pump basket.
• Check for any debris jammed in engine. Refer to section, "Remove
Trapped Debris from Cleaner".
• Check for adequate flow to the cleaner. Refer to section, "Test for
Proper Flow". Adjust valves at the equipment pad to change flow if
necessary.
• Check for air in system. If water level in pump basket drops or you see
excessive air bubbles in the pump basket or coming from the return
lines, there is air in the system. Check hose connections, tighten all
fittings at pump and check o-ring at pump basket for wear.
• Check for adequate flow to the cleaner. Refer to section, "Test for
Proper Flow". Adjust valves at the equipment pad to change flow if
necessary.
• Ensure return fittings are directed down. Add a return diverter if
necessary.
• Make sure hose is not kinked or coiled. Lay in sun to straighten if
necessary.
• Verify correct hose float positioning. Hose float should be on the hose
closest to the cleaner approximately 9 inches from
the cleaner.
• Observe cleaner for more than five (5) minutes and ensure that the
cleaner periodically reverses direction. If it does not, contact your
dealer or service center for help.
• Confirm proper hose length. Refer to section, "Determine the Correct
Hose Length for your Pool."
• Observe cleaner for more than five (5) minutes and ensure that the
cleaner periodically reverses direction. If it is not, contact your dealer or
service center for help.
• Ensure the swivel on top of the cleaner rotates freely.
• Check for adequate flow to the cleaner. Refer to section, "Test for
Proper Flow". Adjust valves at the equipment pad to change flow if
necessary.
• Confirm proper hose length. Refer to section, "Determine the Correct
Hose Length for your Pool." Shorten hose if necessary.
• Check for adequate flow to the cleaner. Refer to section, "Test for
Proper Flow". Adjust valves at the equipment pad to change flow if
necessary.
• Verify hose float is positioned correctly. Hose float should be on the
hose closest to the cleaner approximately 9 inches from
the cleaner.