Hilti TE 30­-A36 Manual De Instrucciones página 15

• Do not operate the cordless tool if signs of damage are found or if parts malfunction. Have the tool
repaired by Hilti Service immediately.
• After cleaning and maintenance, fit all guards or protective devices and check that they function correctly.
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare
parts, consumables and accessories approved by Hilti for use with the product can be found at your
local Hilti Store or online at: www.hilti.group | USA: www.hilti.com
7 Transport and storage of cordless tools
Transport
CAUTION
Accidental starting during transport !
▶ Always transport your products with the batteries removed!
▶ Remove the battery.
▶ Transport the tool and batteries individually packaged.
▶ Never transport batteries in bulk form (loose, unprotected).
▶ Check the tool and batteries for damage before use after long periods of transport.
Storage
CAUTION
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the tool and batteries in a place that is as cool and dry as possible.
▶ Never store batteries in direct sunlight, on heating units or behind a window pane.
▶ Store the tool and batteries in a place where they cannot be accessed by children or unauthorized
persons.
▶ Check the tool and batteries for damage before use after long periods of storage.
8 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
8.1 The combihammer is in working order.
Trouble or fault
The battery runs down more
quickly than usual.
The battery doesn't engage
with an audible click.
The control switch can't be
pressed, i.e. the switch is
locked.
The drive spindle doesn't
rotate.
The combihammer switches
itself off automatically.
2173713
*2173713*
Printed: 07.06.2018 | Doc-Nr: PUB / 5351688 / 000 / 01
Possible cause
Battery condition is not optimal.
The retaining lugs on the battery
are dirty.
The forward / reverse switch is in
the middle position.
The permissible operating temper-
ature of the combihammer's elec-
tronics has been exceeded.
The battery is discharged.
The overload cut-out has been
activated.
Action to be taken
▶ Replace the battery.
▶ Clean the retaining lugs and refit
the battery.
▶ Push the forward / reverse
switch to the right or left.
▶ Allow the combihammer to cool
down.
▶ Change the battery and charge
the empty battery.
▶ Release the control switch.
Allow the combihammer to cool
down. Press the control switch
again. Reduce the load on the
tool.
English 9