Types Of Work; Care And Maintenance Of Cordless Tools - Hilti TE 30­-A36 Manual De Instrucciones

5.1.9 Removing the accessory tool
CAUTION
Risk of injury! The accessory tool gets hot during use.
▶ Wear protective gloves when changing the accessory tool.
▶ Do not place the hot accessory tool on readily flammable materials.
▶ Pull the chuck back as far as it will go and remove the accessory tool.
5.2

Types of work

ATTENTION
Risk of damage by incorrect handling!
▶ Do not operate the switches for direction of rotation and/or function selection during operation.
Observe the safety instructions and warnings in this documentation and on the product.
5.2.1 Function selector switch
▶ Set the function selector switch to the desired working position.
◁ Do not operate the function selector switch while the motor is running. Risk of damage!
5.2.2 Drilling without hammering
▶ Set the function selector switch to this symbol:
5.2.3 Drilling with hammering action (hammer drilling)
▶ Set the function selector switch to this symbol:
5.2.4 Chisel positioning
▶ Set the function selector switch to this symbol:
◁ The chisel can be adjusted to 12 different positions (in 30° increments). This ensures that flat chisels
and shaped chisels can always be set to the optimum working position.
5.2.5 Chiseling
▶ Set the function selector switch to this symbol:
5.2.6 Forward / reverse
▶ Set the forward / reverse switch to the desired direction of rotation.
6

Care and maintenance of cordless tools

WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
Care and maintenance of the tool
• Carefully remove stubborn dirt.
• Clean the air vents carefully with a dry brush.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
Care of the Li­ion batteries
• Keep the battery free from oil and grease.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these may attack the plastic parts.
• Avoid ingress of moisture.
Maintenance
• Check all visible parts and controls for signs of damage at regular intervals and make sure that they all
function correctly.
8 English
Printed: 07.06.2018 | Doc-Nr: PUB / 5351688 / 000 / 01
8
9
10
.
.
.
.
2173713
*2173713*