Manufacturer's Warranty - Hilti TE 30­-A36 Manual De Instrucciones

Trouble or fault
The combihammer or the
battery gets very hot.
The insert tool can't be re-
leased.
The drill bit makes no
progress.
8.2 The combihammer is not in working order.
Malfunction
No LEDs light.
1 LED blinks.
4 LEDs blink.
9 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
10

Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
10 English
Printed: 07.06.2018 | Doc-Nr: PUB / 5351688 / 000 / 01
Possible cause
Electrical fault.
The combihammer has been
overloaded (application limits
exceeded).
Chuck not pulled back fully.
The combihammer is set to run in
reverse rotation.
Possible cause
The battery is not fully inserted.
The battery is discharged.
The battery is too hot or too cold.
The battery is discharged.
The battery is too hot or too cold.
The combihammer has been over-
loaded briefly.
The overheating prevention cut-out
has been activated.
Action to be taken
▶ Switch the combihammer off
immediately. Remove the
battery and keep it under
observation. Allow it to cool
down. Contact Hilti service.
▶ Select a tool that is suitable for
the intended purpose.
▶ Pull the chuck back as far
as it will go and remove the
accessory tool.
▶ Move the forward / reverse
selector switch to the "Forward"
position.
Action to be taken
▶ Push the battery in until it
engages with a click.
▶ Change the battery and charge
the empty battery.
▶ Bring the battery to the recom-
mended working temperature.
▶ Change the battery and charge
the empty battery.
▶ Bring the battery to the recom-
mended working temperature.
▶ Release the control switch and
then press it again.
▶ Allow the combihammer to cool
down and clean the air vents.
2173713
*2173713*