Sony Trinitron PVM-2054QM Manual De Instrucciones página 5

j r j 16:9 selector
Press (light on) for the signal of 16:9 picture.
04] H/V DELAY selector
Press (light on) to observe the horizontal and vertical
sync signals at the same time.
The horizontal sync signal is displayed in the left quarter
of the screen; the vertical sync signal is displayed near
the center of the screen.
HI UNDER SCAN selector
Press (light on) for underscanning. The display size is
reduced by approximately 5% so that four corners of the
raster are visible.
HI BLUE ONLY selector
RESET b u t t o n
Press (light on) to turn off the red and green signals. A
blue signal is displayed as an apparent monochrome
picture on the screen. This facilitates "chroma" and
"phase*" control adjustments and observation of VCR
noise.
* "Phase" control adjustment is effective only for the
NTSC signals.
Press to reset the setting in the menu.
07) DEGAUSS b u t t o n
Press this button momentarily. The screen will be
demagnetized. Wait for 10 minutes or more before
activating this button again.
51 EXT SYNC (external sync) selector
Keep this button in the off position (light off) to operate
the monitor on the sync signal from the displayed video
signal.
Keep this button in the on position (light on) to operate
the monitor on an external sync signal fed through the
EXT SYNC connector on the rear panel.
|]1 LINE/RGB i n p u t selector
Select the program to be monitored. Keep this button in
the off position (light off) to feed a signal through the
LINE A, LINE B or LINE C connectors. Keep this button
in the on position (light on) to feed a signal through the
RGB connectors.
A/RGB selector
When the LINE/RGB input selector is set to LINE (light
off), press this button (light on) to feed a signal through
the LINE A connectors.
When the LINE/RGB input selector is set to RGB (light
on), press this button (light on) to feed the RGB signal.
to
M C/SDI selector
When the LINE/RGB input selector is set to LINE (light
off), press this button (light on) to feed a signal through
the LINE C connectors.
When the LINE/RGB input selector is set to RGB (light
on), press this button (light on) to feed the SDI signal
(optional board is needed).
M B/COMPONENT selector
When the LINE/RGB input selector is set to LINE (light
off), press this button (light on) to feed a signal through
the LINE B connectors.
When the LINE/RGB input selector is set to RGB (light
on), press this button (light on) to feed the component
signal.