Bestron AVC225W Manual Del Usuario página 27

OPERATION - Dry vacuum cleaning
Use the hand-held vacuum cleaner only when the filter is correctly fitted (see 'Cleaning the
filter'). A damaged or incorrectly-fitted filter can cause damage to the appliance.
1. Make sure the hand-held vacuum cleaner's batteries are charged (see Charging the batteries).
2. If so required, fit an accessory to the appliance.
3. Switch on the appliance by sliding the On/Off switch forwards.
4. Switch off the appliance after use by sliding the On/Off switch back.
5. After use, return the appliance to the charging holder.
OPERATION - Wet vacuum cleaning
Use the hand-held vacuum cleaner only when the filter is correctly fitted (see 'Cleaning the
filter'). A damaged or incorrectly-fitted filter can cause damage to the appliance.
1. Make sure the hand-held vacuum cleaner's batteries are charged (see Charging the batteries).
2. Fit the rubber attachement to the appliance.
3. Switch on the appliance by sliding the On/Off switch forwards.
4. Switch off the appliance after use by sliding the On/Off switch back.
5. Empty the liquid from the dust/liquid receptacle
6. After use, return the appliance to the charging holder.
ATTENTION:
• Do not use the appliance to suck up solids and liquids either at the same time or after each other.
• The level of liquid in the dust-liquid receptacle may not rise above the 'MAX.' level.
• Do not hold the hand-held vacuum cleaner vertically upright or downwards, to prevent liquid from
entering the appliance. Empty any liquid in the dust/liquid receptacle before returning the appliance
to the charging holder.
OPERATION - Fitting the asseccories
The hand-held vacuum cleaner is supplied with the following accessories:
- a crevice tool (12), which you can use to clean radiators, window frames, crevices, small openings,
and similar;
- a nozzle with brush (13), which you can use to clean delicate or irregular surfaces;
- a nozzle with rubber attachment (14), which you can use to suck up liquids.
1. Hold the hand-held vacuum cleaner by the handle (6). Make sure you cannot accidentally switch on
the appliance.
2. Slide the nozzle with rubber attachment (14) or the crevice tool into the nozzle of the car vacuum
cleaner.
3. If so required, slide the nozzle with brush (13) onto the crevice tool.
3.
You can store the asseccories by placing them on the holders of the charging station.
4.
27
EN