Fein ASW18-6 Instrucciones De Uso página 22

OBJ_BUCH-0000000252-002.book Page 22 Friday, July 14, 2017 9:34 AM
en
22
Meaning of the LED indicators and the beeps of the power tool.
The following conditions apply for the factory setting. Further indication options are possible
through Parameter Control (see PC software).
LED indica- Meaning
tor
Green LED indicator lights up
(1 second).
Red LED indicator lights up (1 second)
and a short beep sounds.
Yellow LED indicator lights up perma-
nently.
Red LED indicator flashes (1 time per
second) and yellow LED indicator
lights up permanently.
Red LED indicator lights up perma-
nently.
Red and yellow LED indicators light up
permanently.
Red LED indicator flashes (1 time per
second).
Red LED indicator flashes (2 times per
second).
Red LED indicator flashes (1 times per
second).
Yellow LED indicator flashes (1 time
per second).
Explanation
The screwdriving operation has been
carried out properly. The preset shut-
off criterion (e. g. the torque) has been
achieved.
The screwdriving operation has not
been carried out properly. The
required shut-off criterion (e. g. the
torque) was not achieved. Alterna-
tively, a preset error criterion (e. g. a
too large rotation angle) was achieved.
The remaining battery capacity is
below 25 %. The battery must be
changed in foreseeable time.
The battery is discharged and must be
changed.
The power tool has a major defect.
The power tool must be repaired by
the after-sales service.
– Problem with battery. Please contact
the after-sales service.
– The power tool can not be operated
with the battery type being used.
The power tool has a minor defect,
such as blocked motor. The power
tool is blocked in order to protect the
internal components. Remove the bat-
tery and mount it again. Ensure correct
handling when performing the next
screwdriving operation.
The machine is overheated, the over-
temperature protection has
responded. After cooling down, the
machine is ready for operation again. If
the over-temperature protection
responds several times briefly after
each other, have the power tool
checked by the after-sales service.
The battery type is not suitable for this
screwdriving application.
Recommendation: For soft screw-
driving applications at high torque, use
a battery with higher capacity.