Garland CHIPPER 250 E Manual De Instrucciones página 31

Do not allow anybody into the working area. The
working area must have a perimeter of at least 3 metres
in circumference with the machine in the middle.
Do not use accessories with this machine that are not
those recommended by the manufacturer as the use
of non recommended accessories could cause severe
damages to the end user, those people in the vicinity
and to the machine itself.
Utilización de la máquina:
Usage of the machine:
Start the machine following the instructions as per
points 6.3 and 6.4.
Feed the shredder with material by using the hopper.
If the material to be shredded does not have a large
volume the shredder will suction the material, will shred
it and will expel through the ejection mouthpiece.
Insert an adequate amount of material in the hopper.
Do not insert too much material as the machine will
block itself.
Check all the shredding material carefully. Make
sure it does not contain stones, screws or any other
material that could cause a breakage to the shredder.
Caution: The material inserted in the
hopper can move around and whiplash
as the blades suction the material as
well as small material can be expulsed. Maintain
an adequate security distance and always wear
protective goggles, ear protectors and long gloves.
Check that the shredded material is ejected without
problems. If the shredded material accumulates
around the ejection area, stop the machine and clean
this area.
If you desire a fi ner shredding performance, you can
shred the material more than once.
Should you when feeding the shredder, hear strange
noises, turn off the machine immediately.
Blockage of the shredder:
If too much material or if the material is too resistant,
the blades will not be able to cut and the shredder
will stop.
Should this happen follow steps as per 6.6. Start
shredding again with lighter material or in less
quantity.
Shredding tips:
If the material to be shredded contains big quantities
of water and resin, it can block the shredder. We
suggest you allow these materials to dry fi rst.
Bigger branches are shredded best straight after
cutting. If allowed to dry, the shredder will need more
effort for the same job.
If you are going to shred branches and pruning
remains, alternate these to minimize blockages.
7.1. FINISHING USAGE
When you stop using the machine:
1. Disconnect the machine by placing the switch in
the ¨O¨ position.
2. Unplug the machine from the mains.
3. Clear the hopper and the ejection area.
4. Open the cover and remove any rests of material
from the blades.
31/96
English