Machine Usage - Garland CHIPPER 250 E Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

English
This position will only be used to unblock the blades of
the shredder. In this position the blades rotate in the
opposite direction to unblock the blades.
Note: When the forward/Backward switch is in position
, the On/Off switch is blocked in such a way that
when pressing the green button ¨I¨, this will not be
connected. You will have to keep the ¨I¨ button pressed
down if you want the blades to move. When you stop
pressing down the engine will stop automatically.
6.6. PROTECTION AGAINST AN OVERCHARGE
This shredder has a security switch that will
disconnect the machine in the following situations:
• If too much material is accumulated on the blades.
• If the material to be shredded is too resistant for
the engine capacity.
• When there exists a high resistance on the blades.
If you detect that the machine does not start when
the switch is in the ¨I¨ position it will probably be
because the security switch is activated. In this case,
disconnect the machine from the mains and place the
forward/backward switch in the ¨O¨ position. Check
that the blades are clean and no material is impeding
its correct movement and fi nally wait fi ve minutes
before restarting the machine.
To restart the machine after a security stoppage:
1. Disconnect the machine from the mains.
2. Place the forward/backward switch in the ¨O¨
position.
3. Clean all the material that is inside the machine.
4. Wait 5 minutes.
5. Press the overcharge protection button to restart
the machine.
6. Place the forward/backward switch in the
backward position
.
7. Press the On/Off switch in the ¨I¨ section to ensure
that is no material in between the blades (if there
was material, disconnect from the mains and
remove).
8. Stop pressing the On/Off switch in the ¨I¨ section.
9. Place the forward/backward switch in position
10. Start the shredder by pressing ¨I¨ in the On/Off
switch.
6.7. CHECKING POINTS AFTER START UP
Check that the shredder once started but with no work
load starts correctly, the engine runs smoothly and
the blades do not hit against any element. If you hear
any strange noises or you detect that the machine
does not work properly, stop the machine and check
if there are residues or other strange elements in the
machine. If the problems persist, take the machine to
your nearest authorised after sales service.

7. MACHINE USAGE

Use this machine only for its designed use. The use of
this machine for other chores is dangerous and could
cause injuries to the end user and to the machine.
Do not use this machine if tired, sick, if you
have had medicines, drugs or alcohol.
Do not use the machine at night, with fog or with
reduced visibility as the working area must always be
fully visible.
Lack of rest and fatigue can cause accident and
damages.
Limit the time of continued usage to 10 minutes and
rest between 10 and 20 minutes between working
stints.
Never leave the machine unattended.
30/96
.

Publicidad

Tabla de contenido
loading

Tabla de contenido