Aluminium Processing; Service And Maintenance; Accessories, Tools - Festool MFK 700 EQ Manual De Instrucciones

b) Edge trimming with bearing guide
Use routing tools with a bearing guide in the ma-
chine when edge trimming with the large surface
router table. The machine is then guided in such
a way that the bearing guide rolls off the work-
piece.
When trimming edges, always use the undertable
extractor adapter [10-1] for improved dust extrac-
tion.
c) Edge trimming with sensor and router table for
edge veneer
1,5°
When edge trimming with the router table for edge
veneer (only in SET scope of delivery), fi t the sensor
[11-1] to the machine (see "Router table for edge
veneer "). The machine is then guided in such a way
that the sensor rests against the workpiece.

Aluminium processing

Risk of accident - always perform
the following safety measures when routing alu-
minium:
 Add a residual-current circuit-breaker (FI,
PRCD).
 Connect the machine to a suitable dust extrac-
tor.
 Remove dust deposits from the motor housing
on a regular basis.
 Wear protective goggles.
10- 1
11- 1

Service and maintenance

Any maintenance or repair work
that requires opening of the motor or gear hous-
ing should only be carried out by an authorised
Customer Service Centre (name supplied by your
dealer)! Maintenance or repair work carried out
by an unauthorised person can lead to the wrong
connection of the power leads or other components,
which in turn can lead to accidents with serious
consequences.
To prevent accidents, always re-
move the plug from the power supply socket
before carrying out any maintenance or repair
work on the machine! Do not use compressed
air to clean the electrical tool! Do not try to clean
parts inside the machine in this way, as you could
let foreign objects in through the openings of the
machine housing.
Certain cleaning agents and solvents
are harmful to plastic parts. Some of these are:
gasoline, carbonyl chloride, cleaning solutions con-
taining chlorine, ammonia and household cleaners
containing ammonia.
 To assure the circulation of air, the cool air vents
in the motor housing must always be kept clear
and clean.
 This unit is fi tted with special, automatically
disconnecting carbon brushes. If these become
worn, the current is automatically switched off
and the unit shuts down. In this case, take the
unit to an authorised Customer Service Centre
and have the carbon brushes changed.

Accessories, tools

For safety reasons, only use origi-
nal Festool accessories and tools!
The accessory and tool order number can be found
in the Festool catalogue or on the Internet under
www.festoolusa.com.
Many Festool products are shipped in a unique
system container, called "Systainer". This provides
protection and storage for the tool and accessories.
The Systainers are stackable and can be interlocked
together. They also can be interlocked atop Festool
CT dust extractors.
– To open the Systainer:
• Turn the T-loc [12.1] to the position
12
Systainer
.