Intended Use; Control Elements; Safety Instructions; Original Operating Manual - Festool BG-RG 150 Manual De Instrucciones

Floor Guide BG-RG 150 –
Original instruction
1 Symbols
Warning of general danger
Risk of electric shock
Read the operating instructions/notes!
Do not throw in the household waste!
2 Technical data
Nominal voltage
Mains frequency
Connected load to appliance plug socket
Weight
Protection class
3

Intended use

The BG-RG 150 fl oor guide serves to guide the
RG 150 E renovation miller along the fl oor in an
upright position. The ballast, which is included
ensures optimal down force. The wheels make the
transport of this assembly between workplaces
easier.
The manufacturer accepts no liability for possible
damage or accidents caused by using or operating
the device inappropriately or incorrectly.
4

Control Elements

[1-1] Miller pins
Fastening bolts
[1-2]
[1-3] Vacuum cleaner suction tube
Velcro strips
[1-4]
[1-5] Flexible power cord for miller
Frame with handles
[1-6]
Power socket of the fl oor guide
[1-7]
Flexible power cord of the fl oor guide
[1-8]
Miller switch
[1-9]
[1-10] Latch
[1-11] Bolts
[1-12] Wheels
[1-13] Ballast
5
ings and instructions may result in electric shock,
fi re and/or serious injury.
Save all warnings and instructions for future
reference.
The term „power tool" in the warnings refers to
your mains-operated (corded) power tool or bat-
tery-operated (cordless) power tool.
- The tools must not be used in damp, wet areas,
- By connecting the fl oor guide with the miller a
220 – 240 V ~
- Turn the attached miller on and off only using
50/60 Hz
- Before each use inspect the machine, fl exible
max.: 1600 W
10.8 kg
I
- Before assembling the fl oor guide system you
- Do not use the fl oor guide system as an exten-
6
1. Place the wheels [1-12] to the ballast [1-13]
2. Seat the fl oor guide from above on to the miller
3. Attach the suction hose of the vacuum cleaner
4. Wind the fl exible power cord of the miller [1-5]
Removal should proceed in reverse order to the
fi tting process

Safety Instructions

WARNING! Read all safety warnings and
all instructions. Failure to follow the warn-
outside during rain, fog, snow and in environ-
ments where there is a danger of explosion.
device is created for which safety instructions
and the user's manual of the given miller apply.
the switch on the fl oor guide.
power cord and the power plug. Have defects
remedied by an expert.
must unconditionally disconnect the power
plug of the miller and the fl oor guide from the
mains.
sion cord for other machines.
Assembly Instructions
and bolt in using four bolts [1-11]. Maintain
the correct orientation. Tighten with a torque
of 8 Nm – see pic [1 a].
pins [1-1] and tighten three fastening bolts [1-
2] to attach it.
[1-3] to the suction nozzle. Attach it to the fl oor
guide using the Velcro strips [1-4].
around the frame with the handles [1-6] and
insert into the power socket of the fl oor guide
[1-7].
5