Original Operating Manual; Scope Of Delivery; Intended Use; Technical Data - Festool KB-KA 65 Manual De Instrucciones

Original operating manual

1 Symbols
Warning of general danger
Manual, read the instructions
Do not throw in the household waste.
Risk of injury from sharp blade
Machining rectangular workpieces
Machining round
workpieces
Tip or advice
2

Scope of delivery

– Edge cutter KP 65/2 [Fig. 1 - 10]
– Edge magazine KSP-KA 65 [Fig. 11 + 12]
– Additional roll ZR-KA 65 [Fig. 13]
– Scraper ZK-HW 45/45 [Fig. 14]
– Plastic sliding plate LAS-STF-KA 65 with scratch
protector EF-LAS-STF-KA 65/3x [Fig. 15]
– Polishing felt PF-STF 80 x 133 STF-H/5x
– Hand sanding block HSK 80 x 133 H
– Polish MPA 600
– Hand abrasive Brilliant 2
3 General safety instructions
Warning! Read and observe all information
and safety instructions.Ignoring warning notes
and instructions may lead to electric shocks, fires
and/or cause serious injury.
Keep all safety information and other instructions
in a safe place for future reference.
The user is liable for improper or non-in-
tended use.
4 Edge cutter KP 65/2
4.1

Intended use

The edge trimmer MFT/3 is specifically designed
for trimming plastic edge bands on rectangular and
round workpieces.
4.2

Technical data

Edge trimmer
Edge height
Edge thickness
*
Depending on material
4.3

Machine features

[1-1] Edge length scale
[1-2] Rotary knob
[1-3]
Edge length fine adjuster
[1-4] Stop pin
[1-5] Trimming fixture with blade
[1-4]
Handles
[1-7] Internal stop
The specified illustrations appear at the beginning
of the Operating Instructions.
4.4

Machine-related safety instructions

Warning! Read and observe all information
and safety instructions.Ignoring warning notes
and instructions may result in serious injuries from
the sharp blade on the trimming fixture.
Keep all safety information and other instructions
in a safe place for future reference.
4.5 Settings
Fitting the stop pin for rectangular workpieces [2]
The stop pin [1-4] is located in this position
when the machine is delivered.
Insert the stop pin [1-4] into the rear recess on

the edge trimmer [2 A].
Insert the rotary knob [1-2] into the opening

above the stop pin [1-4] [2 B].
Tighten the rotary knob [1-2] by turning clock-

wise [2 C].
Disassembly
Removal in reverse order.
Fitting the stop pin for round workpieces [3]
Insert the stop pin [1-4] into the recess under

the fine adjuster for the trimming length [1-3]
[3 A].
Insert the rotary knob [1-2] into the opening

above the stop pin [1-4] [3 B].
Tighten the rotary knob [1-2] by turning clock-

wise [3 C].
Slacken the rotary knob [1-2] by turning anti-

clockwise half a revolution so that the fine ad-
juster for the edge length [1-3] moves freely [3
D].
KB-KA 65
GB
KP 65/2
*
18 - 65 mm
*
0,5 - 3,0 mm
9