Stihl MSA 160 C Manual De Instrucciones página 33

Remove the filler cap.
N
Filling Chain Oil Tank
Take care not to spill chain oil during
refilling and do not overfill the tank –
leave approx. 1/2" (13 mm) air space.
Closing
Handle is in an upright position:
Position filler cap – markings on filler
N
cap and housing must align.
Push the filler cap down as far as it
N
will go.
MSA 160 C, MSA 200 C
Push the filler cap down and twist it
N
clockwise until it engages.
Then the marking on filler cap and the
"closed" marking on housing will align.
Flip the handle down.
N
Filler cap is now closed.
If the filler cap will not engage into the
tank housing
The base of the filler cap is rotated in
relation to the upper part.
Look at the black alignment marks
N
on the top of the filler cap.
1
Left: Base of filler cap is rotated to
the closed position – interior
marking (1) is aligned with
the exterior marking.
Right: Base of filler cap is in the cor-
rect position for installation –
interior marking is below the
clip. It does not align with the
exterior marking.
English
31