Problem found
The machine is not switching on.
The lights fl ash rapidly.
The capsule loading arm does not
reach the closed position.
The pump is not starting.
The machine does not brew any
coff ee.
The coff ee is not hot enough.
Coff ee fl ows too quickly, foam is
not formed on the espresso.
The machine takes a long time to
warm up.
For problems not covered in the above table or if the suggested solutions do not solve them, please contact
· Voltage: 220-240 V / 50-60 Hz
· Power value: 1000 W
· Capacity of tank: 1800 cc
· Weight: 14 kg
· Materials used for the body: black glass
SOLUTION FOR MOST COMMON PROBLEMS
Possible causes
»
Machine is not connected to
the electric supply.
»
There was a technical failure.
»
Full used capsule drawer/ drip
tray.
»
Capsule inserted incorrectly.
»
There is no water in the tank.
»
The capsule is not inserted.
»
The operating temperature is
not reached.
»
Capsule loading arm is raised.
»
There is no water in the tank.
»
Filter inserted incorrectly.
»
The coff ee cups are cold.
»
You inserted an already used
capsule.
»
The machine has a lot of
limescale.
Lavazza customer service.
SPECIFICATIONS
For technical specifi cations please refer to the information plate on the machine.
Solution
»
Check the machine is correctly plugged in.
»
Contact Customer Service or service
centre.
»
Empty the used capsule drawer/ drip tray.
»
Raise the capsule loading arm and insert
the capsule correctly.
»
Refi ll with fresh drinking water.
»
Insert the capsule.
»
Wait for reaching the suitable temperature.
»
Lower the capsule loading arm.
»
Refi ll with fresh drinking water and repeat
the loading of the hydraulic system.
»
Check the Brita® fi lter insertion (see
instructions with the fi lter).
»
Preheat the coff ee cups with hot water.
»
Insert a new capsule.
»
Descale the machine.
· Machine dimensions:
Height 36,5 cm - Width 31,5 cm - Depth 31,0 cm
· Stand dimensions:
Height 90 cm - Width 31,5 cm - Depth 31,0 cm
2006/42 CE – 2004/108 CE – 2006 /95 CE
E N
21