Preparation For Measurement - Seca 984 Manual De Instrucciones Y Garantía

Preparation for measurement

The equipment trolley allows the bed scale to be used on a mobile basis, but the scale
can also be permanently installed.
– Move the equipment trolley next to the
bed.
– Press the brakes down onto the cas-
tors to lock the trolley in position.
– Remove one measuring foot and place
it next to one of the bed castors. Fold
out the actuating lever. To unlock the
lever, press down the round knob.
– Keep the actuating lever at an angle of
approx. 45° to the floor and push the
measuring foot up against the bed. The
oscillating arm should now be next to
the bed castor.
– Now push the measuring foot further
forward – holding the oscillating arm
firmly in the other hand. The oscillating
arm is now under the bed castor.
– Press the actuating lever downwards.
– The measuring foot moves under the
castor, lifting the bed.
The floor under the measuring foot should
be level. You must make sure that the con-
necting cable is not caught under the
measuring foot, otherwise faulty measure-
ments may result.
Model 984
GB
23