Checking The Oil Level - Dometic TEC 60EV Instrucciones De Uso

Operating the generator
Display message
Description
Engine lost comm
Inverter failed
Eng. Param. Error
Inv. Param. Error
Software Error
8.7

Checking the oil level

!
CAUTION! Risk of injury
Hot oil can cause burns.
Only check the oil level when the generator is switched off.
I
NOTE
The generator must be level.
Always check the oil level before use. To do this, proceed as follows:
➤ Open the generator flap.
➤ Switch the generator to no function with the main switch (fig. 4 1, page 4).
➤ Disconnect the positive terminal of the supply battery.
➤ Take the dipstick (fig. 4 2, page 4) out of the filler neck (fig. 4 3, page 4).
➤ Clean the dipstick (fig. 4 2, page 4) with a cloth.
➤ Put the dipstick (fig. 4 2, page 4) back into the filler neck (fig. 4 3, page 4).
➤ Take the dipstick (fig. 4 2, page 4) out of the filler neck.
18
Generator behaviour
The generator stops.
The generator stops.
The generator stops.
The generator stops.
The generator stops.
TEC60EV
Measures
Check the system by referring to
the troubleshooting table.
If the problem persists, contact
the manufacturer's branch office
in your country (see back page).
Contact the manufacturer's
branch office in your country (see
back page).
Contact the manufacturer's
branch office in your country (see
back page).
Contact the manufacturer's
branch office in your country (see
back page).
Contact the manufacturer's
branch office in your country (see
back page).
EN