Checking The Oil Level; Switching To Automatic Mode - Dometic TEC29 Instrucciones De Uso

Operating the generator
8.7

Checking the oil level

CAUTION!
!
Hot oil can cause burns.
Only check the oil level when the generator is switched off.
NOTE
I
The generator must be level.
Always check the oil level before use. To do this, proceed as follows:
➤ Open the generator flap.
➤ Switch the generator to no function with the main switch (fig. 4 1,
page 4).
➤ Disconnect the positive terminal of the supply battery.
➤ Take the dipstick (fig. 4 2, page 4) out of the filler neck (fig. 4 3,
page 4).
➤ Clean the dipstick (fig. 4 2, page 4) with a cloth.
➤ Put the dipstick (fig. 4 2, page 4) back into the filler neck (fig. 4 3,
page 4).
➤ Take the dipstick (fig. 4 2, page 4) out of the filler neck.
➤ Check that the oil level is between the notch (maximum filling level) and
the tip of the dipstick (fig. 4 4, page 4).
If not, top up with more oil.
➤ Put the dipstick (fig. 4 2, page 4) back into the filler neck (fig. 4 3,
page 4).
➤ Connect the generator to the positive terminal of the supply battery.
➤ Switch the generator to standby with the main switch (fig. 4 1, page 4).
➤ Close the generator flap.
8.8

Switching to automatic mode

You can only switch to automatic mode:
 if it was configured when the generator was installed
 if the vehicle is stationary and the ignition is switched off
 if the automatic mode switch (if available) is switched on
 if the winter storage switch (if available) is switched off
44
TEC29, TEC29LPG
EN