Assembly; Frame; Armrests; Leg Supports - Vermeiren INOVYS Manual De Instrucciones

GB
ASSEMBLY OF THE WHEELCHAIR
Note the following before assembling the wheelchair:

FRAME

A

ARMRESTS

1

LEG SUPPORTS

B
2
3
1
3
After you have taken the wheelchair out of the original
packaging, push the backrest to the back into the 90°
position. Guide the safety pins (A) into the appropriate
socket to peg the spring (B), which is located at the
back under the seat.
L
Make sure that the ring of the pin is closed.
L
Make sure that no cables are squashed.
Put the armrests to the left and the right into the
brackets provided for this purpose. Pull out the screw
(1). Guide the armrest from above into the bracket (2)
provided. Let go of the screw (1) and this will stop the
armrest. Turn the screw clockwise until it is finger-tight
(3) so that the armrest is also secured. To loosen and
remove the armrest, proceed in the reverse order.
L
Make certain before use that the armrests are
firmly fixed.
Grasp the leg support on the upper handle by guiding
your finger through the handle. From above press with
your thumb on the hatched surface of the leg support
handle (1) and the lock of the leg support is loosened.
Pull the leg support vertically up to remove the leg
support (2).
If you want to swivel the leg supports to the side, pull
the leg supports up by about 0.98 inch and set the
2 swivelling block to the side on the receiver block of the
leg support (3).
To insert the leg support, grip the leg support on the
upper handle, press on the hatched surface of the leg
support handle (1) and guide the narrow axle into the
leg support receiver. The leg support block and the
leg support receiver have to lie flush in each other,
only then is the floating axle locked and the leg
support secured.
L
Make sure that the axle is locked before using
the leg support.
6
INOVYS
12/2008