Speed Setting For Each Material - Festool HK 55 EBQ Manual De Instrucciones

English
– Always secure the workpiece in such a
manner that it cannot move while being
processed.
– Always hold the machine with two hands at
the handles [1-1] when performing work.
This reduces the risk of injury and is a pre­
requisite for precise work.
Always push the saw forwards [8-9], and
–
never towards yourself.
– Adapt the infeed speed to prevent the cut­
ters on the saw blade from overheating and
prevent plastic materials from melting dur­
ing cutting.
Make sure that the knob [1-12] is tightened
–
before starting work.
– Do not use the machine when the electron­
ics are faulty because the machine may op­
erate at excessive speeds. An absence of
the smooth start-up function or speed con­
trol indicates that the electronics are faul­
ty.
8.1 Sawing along the scribe mark
The cut indicators display the cutting sequence
without a guide rail:
0° cuts: [7-1]
45° cuts: [7-2]
8.2 Cutting sections
Position the saw with the front part of the saw
table on the workpiece, switch on saw and push
forward in cutting direction.
8.3 Sawing cut-outs (plunge cuts)
In order to avoid kickbacks, the following
instructions must be observed without fail when
plunge cutting:
8.4

Speed setting for each material

Material
Solid wood (hard, soft)
Chipboard and hardboard
Laminated wood, blockboard, veneered and laminated panels
Plastics, fibre-reinforced plastics (FRP), paper and mesh
Acrylic glass
Gypsum and cement-bonded fibreboard
Aluminium panels and profiles up to 15 mm
22
– Always position saw with the rear edge of
the saw table against a fixed stop.
– When working with the guide rail, place the
saw against the kickback stop FS-RSP (ac­
cessories) [8-6] clamped to the guide rail.
CAUTION
Danger of crushing
► Always keep a firm grip on the machine
with your free hand when adjusting plunge
cuts.
► Never position your fingers behind or be­
low the saw blade.
Procedure
► Adjusting cutting depth, see section
► Press lever [8-1] down.
Sawing unit swivels upwards to plunge-cut
position.
► Hold retractor lever [8-2] downwards as far
as stop.
Pendulum guard [8-4] opens and the saw
blade is exposed.
► Position saw on workpiece and position
against a stop (kickback stop).
► Switch on saw.
► Slowly press down saw to the set cutting
depth until the saw engages, release re­
tractor lever [8-2] and push forward in cut­
ting direction [8-9].
The notch [8-3] indicates the absolute rear cut­
ting point of the saw blade (Ø 160 mm) when
using the saw at maximum cutting depth with
the guide rail.
7.2 .
Speed range
6
3–6
6
3–5
4–5
1–3
4–6