Prepare Measurement - Beurer BC 58 Manual De Instrucciones

2. Supported architectures:
• x86 (32 bit)
• x64 (64 bit)
3. Hardware requirements:
• Recommended: at least Pentium 1 GHz or faster with at
least 1 GB RAM
• Free memory on the primary partition of at least:
– x86 – 600 MB
– x64 – 1.5 GB
• Graphic resolution from: 1024 x 768 pixels
• USB port 1.0 or later

4. Prepare measurement

Inserting battery
• Open the battery compartment lid.
• Use exclusively brand-name batter-
ies of the type: 2 x 1.5 V Micro (Alkaline
Type LR 03). Making absolutely sure
that you insert them with the correct polarity as marked. Do
not use rechargeable batteries.
• Replace the battery cover carefully.
If the battery change
urement is no longer possible and you must replace all
the batteries. Once batteries have been removed from the
device, the time must be reset.
is continuously illuminated, meas-
The empty, completely flat batteries must be disposed of
through specially designated collection boxes, recycling
points or electronics retailers. You are legally required to dis-
pose of the batteries.
The codes below are printed on batteries
containing harmful substances:
Pb = Battery contains lead,
Cd = Battery contains cadmium,
Hg = Battery contains mercury.
Setting date and time
You should set the date and time without fail. Otherwise,
you will not be able to save your measured values correctly
with a date and time and to access them again later.
Tip: If you press and hold the MEM button, you can set the
values more quickly.
To set the date and time, proceed as follows:
• Move the touch screen activation switch to the ON position.
• Press the START/STOP and MEM buttons simultane-
ously, 24h begins to flash. Select 12h or 24h mode using
the MEM button. Press START/STOP to confirm your
selection. The year display will start to flash. Set the year
with the MEM button and confirm with START/STOP
• Then set the month, day, hour and minutes and confirm
each setting with START/STOP
• Pressing the START/STOP button
display off.
23
.
.
again will switch the