Prepare Measurement - Beurer BM 26 Manual De Instrucciones

Icons in the display:
1. Systolic pressure
2. Unit in mmHg
3. Diastolic pressure
4. Pulse symbol and calculated pulse value
5. Time and date
6. Cardiac arrhythmia symbol
7. Average values of the 3 most recent measurements – AVG
8. Pump up, release air (arrow)
9. Risk indicator
10. Battery replacement symbol
11. Symbol for users 1, 2, 3 and 4
11
10
9
8
7
6
5
1
2
3
4

4. Prepare measurement

Inserting battery
• Remove the battery cover from the
back of the monitor.
• Insert four AA 1.5 V alkaline batter­
ies. Making absolutely sure that you
insert them with the correct polarity
as marked. Never use rechargeable
bat teries.
• Replace the battery cover carefully.
If 4 warning tones have been sounded and the symbol
appears simultaneously on the display, it is no longer possible
to perform a measurement and all batteries must be replaced.
Once the batteries have been removed from the device, the
time must be set again. The empty, completely flat batteries
must be disposed of through specially designated collection
boxes, recycling points or electronics retailers. You are legally
required to dispose of the batteries.
The codes below are printed on batteries containing
harmful substances: Pb = Battery contains lead,
Cd = Battery contains cadmium,
Hg = Battery contains mercury.
Setting date and time
You should set the date and time without fail. Otherwise, you
will not be able to save your measured values correctly with
a date and time and to access them again later. The time is
shown in 12­hour format i.e. the time from 13:00 is displayed
as 01:00 PM.
17
4 x AA (LR06) 1,5 V