Baxtran BR 40 Manual De Usuario página 39

6.6 TOTAL ACCUMULATED
• You can configure the indicator to manually accumulate by pressing the key
the selection of the mode using the "F5 PRT". The accumulation function is only available when weighing is on. Is desactivate when the
indicator is in counting mode.
• The weight shown on the display will be stored in the memory when you press the key
• The display will show "ACC 1" and then the total stored registers in memory will be shown for two seconds before return to the normal mode.
If the viewer features the optional RS-232 interface, the weight will go to a printer or PC.
• Remove the weight allowing the viewer returning to zero and set a second weight on the platform. Press the key
show "ACC 2" and then the new total.Continue untill all the weight resgisters will be added.
• For view the total stored in memory, enter in the section of SETUP and use the function "F1 TOL", by selecting the desired option [ To Clr ],
[ To P-C ], [ To Prt ].
To Clr
To P-C
To Prt
6.7 BALANCES FOR ANIMALS
(Feature only available in of balance for animals mode).
This range of viewers can be used as balance for animals when the external resolution is less than 1/3000. For configuration in this mode,
check section 12 TECHNICAL CONFIGURATION. (Parameter P4 chk - Mode 2).
Place the animal on the platform. After few seconds, if the data read is stable, you will hear beeps that will be signature you that the data read
data are being recorded. After the animal descaens from the platform the reading of data will go back to zero and the viewer will automatically
make the operation automatically. If you had connected the printer, it will automatically print.
To clear the accumulated memory, press the key
6.8 HOLD MODE / PEAK
For its configuration, see section 12 TECHNICAL SETUP (parameter P4 chk-Mode 4). This feature allows you to keep on the display (HOLD),
the peak of maximum weight, until you press the key
38
Clears the memory without printing the results
Prints the total accumulated and then clears the memory
Prints the total accumulated and will not erase the memory
. See the Configuration section for more details concerning
when the balance is in the zero point.
. This function will be activated with on exceeding weight of 20e.
USER'S MANUAL BR40
if this is stable.
and the display will
EN