Tabla de contenido
Publicidad
1
4
5
6
20
2
3
7
8
9
4-6
Layout
4. + key
To increase an input value (e.g. rim diameter, offset,
10
rim width).
Hold down to change the value shown automatically.
5. Enter key
Press to confi rm input (dimension, mode) or save
"user" settings. The unit will beep.
6. - key
To decrease an input value (e.g. rim width, offset,
rim diameter).
Hold down to change the value shown automatically.
7. * key with indicator
Press to scroll along the special modes.
The * key indicator will light up, the unit will beep.
8. Fine key (Lens)
8. Fine key
Press to toggle the read-out accuracy between
Press to toggle the read-out accuracy between 5
Normal, i.e. 0,25 oz (5 grams) and Fine i.e. 0.05 oz
and 1 grams (0,25 resp. 0,05 oz.). The unit will
(1 gram) regardless of the registered value. The
beep.
unit will beep. Release the key to return to normal
Combined with the * key, it starts the calibration
accuracy. Combined with the * key, it starts the "user
function.
calibration" function.
9. Weight key
Press to select the required weight application
mode (weight mode), the unit will beep.
Combined with the * key, it starts the "user" function.
Note: If pressed for at least three seconds, it recalls
directly the Normal mode (Clip-Clip) and reduces
the number of ALU modes that can be selected
"Quick ALU Mode" (
10.Stop key
Press to stop a spinning wheel.
Note:
The STOP key also has an instant stop function.
F
5.5).
Publicidad
Tabla de contenido
