Measuring Imbalance - Sun SWB 300 Manual De Operador

Equilibradora para ruedas
Tabla de contenido

Publicidad

46
Operation
5.8
Balancing
Preliminary operations:
– If necessary, perform a compensation run (C4
7.1.1).
– Check the wheel is clamped correctly (
– Read the rim dimension parameters (
If more than one wheel of the same type needs to be
balanced (the same nominal dimensions) the data need
only be set for the fi rst wheel. The selections stay set
until other new data is set or the machine is switched off.
5.8.1

Measuring imbalance

Having completed the preliminary operations, a
Measuring run can be launched:
Wheel measuring run PROFILING mode
— Lower the wheel guard from the fully raised position.
Pull the guard smoothly at medium speed, without
stops or jerking even to the side.
Note:
You must be very careful when lowering
the guard, as the machine simultaneously
scans the wheel external rim profile
(ultrasonic
After measurement the balance weights can be fi tted,
or a weight minimisation or optimisation run can be
F
carried out (
5.11).
After measurement the machine stops automatically
and the wheel is braked.
The screen shows the unbalance measured for each
correction plane and the direction towards correction.
F
5.1).
F
5.6).
detector).
F

Publicidad

Tabla de contenido
loading

Tabla de contenido