Sun SWB 300 Manual De Operador página 66

Equilibradora para ruedas
Tabla de contenido

Publicidad

1
2
3
4
A
5-38
66
5
5-32
5-34
5-37
B
5-39
Operation
Option 2: Do not turn the tyre over on the rim
Press the
FINE
key (3).
The result is recalculated.
Reading
OP.7 - II
or H0 or H2 appears
To go to
II - OP.7
(turning over the tyre) press the
FINE
key (3) again.
Option 3: Abort optimisation
Press the STOP key (5) to exit the OP program and
return to the balancing program.
The imbalance on the wheel is shown on the readout.
Balance the wheel according to the readings.
Reading
OP.7 - II (Fig. 5-37)
Readjust the tyre on the rim (the right display bars light
up permanently).
Option 1: Readjust the tyre on the rim
(normal program)
Readjust the wheel following the right direction
indicator and make a double mark on the right side
of the tyre exactly perpendicular to and above the
main shaft
(Fig.
5-38).
Remove the wheel from the machine
Readjust the tyre on the rim until the double mark
coincides with the valve
Clamp the wheel on the balancer and readjust so
that the valve is exactly perpendicular to and above
the main shaft.
Press the ENTER key
position.
Reading OP.8 appears
(Fig.
Spinn the wheel (START) (check run).
If balancing optimisation (silent running) has been
carried out correctly according to the program cycle,
after the check run the machine automatically returns to
the type of weight positioning previously selected and
indicates the residual dynamic imbalance on the wheel.
Balance the wheel according to the readings.
Both optimisation and balancing are accomplished.
Message E9
Message E9 means that at least one error occurred
during the optimisation cycle. Press the STOP key
(5) to exit the optimisation program and repeat
optimisation if necessary.
Option 2: do not adjust the tyre on the rim
Press the STOP key (5) to exit the OP program and
return to the balancing program.
The imbalance on the wheel is shown on the readout.
Balance the wheel according to the readings.
Reading H0
Press the STOP key (5) to exit the OP program and
return to the balancing program.
The imbalance on the wheel is shown on the readout.
Balance the wheel according to the readings.
(Fig.
5-39).
(1)
to acquire the valve
5-34).

Publicidad

Tabla de contenido
loading

Tabla de contenido