Sun SWB 300 Manual De Operador página 72

1
2
3
4
A
5-38
72
5
5-32
5-37
5-34
B
5-39
Operation
Balance the wheel according to the readings.
•
Both weight minimisation and balancing are accomplished.
Message E9
Message E9 means that at least one error occurred
during the minimisation cycle. Press the STOP key
(5) to exit the minimisation program and repeat
minimisation if necessary.
Option 2: Do not turn the tyre over on the rim
Press the FINE key (3).
•
The result is recalculated.
Reading Un.7 - II or H0 appears
Option 3:
Press the STOP key
•
program and return to the balancing program
The imbalance on the wheel is shown on the readout.
Balance the wheel according to the readings.
•
Reading Un.7 - II (Fig. 5-37)
Readjust tyre on the rim (the right display bars light
up permanently).
Option 1: Readjust the tyre on the rim
(normal program)
Readjust the wheel according to the right direction
•
indicator and make a double mark on the right side
of the tyre exactly perpendicular to and above the
main shaft (Fig. 5-38).
Remove the wheel from the machine.
•
Readjust the tyre on the rim until the double mark
•
coincides with the valve
Clamp the wheel on the balancer and readjust it so
•
that the valve is exactly perpendicular to and above
the main shaft.
Press the ENTER key (1) to acquire the valve
•
position.
Reading Un.8 appears (Fig.
Spinn the wheel (START) (check run).
•
If weight minimisation was carried out correctly
(according to the program cycle), the machine
automatically returns to the type of weight positioning
previously selected and indicates the residual dynamic
imbalance on the wheel.
Balance the wheel according to the readings.
•
Both weight minimisation and balancing are
accomplished.
Message E9
Message E9 means that at least one error occurred
during the minimisation cycle. Press the STOP key
(5) to exit the minimisation program and repeat
minimisation if necessary.
(5) to exit the minimisation
(Fig. 5-39).
5-34).