Symbols; Technical Data; Prescribed Usage - Protool RGP 80-11 E Manual De Instrucciones

Renovation Cutter
RGP 80-11 E
Table of contents
1 Symbols ................................... 13
2 Technical data ........................... 13
3 Prescribed usage ........................ 13
4 Control Elements ....................... 14
5 Notes on Safety Prevention ......... 14
5.1 General Safety Instructions ......... 14
5.2 Safety instructions for all work
activities ................................... 14
5.3 Additional safety instructions
for all types of works .................. 15
5.4 Supplementary safety instructions
for grinding and cutting .............. 16
5.5 Additional safety instructions
for surface grinding .................... 16
5.6 Additional safety instructions
for grinding with wire brush ......... 16
5.7 Turner safety instructions ............ 16
5.8 Noise / Vibration Information ........ 17
6 Activation ................................. 17
6.1 Switching on - off ....................... 17
6.2 Motor electronics ....................... 17
7 Milling tools ............................... 18
7.1 Choice of cutter and grinding
head ........................................ 18
7.2 Cutter / Grinding head change ...... 18
7.3 Replacing Grinding Wheels .......... 18
8 Operation ................................. 19
8.1 Suction system .......................... 19
8.2 Additional handle ....................... 19
9 Maintenance .............................. 19
10 Environmental Protection /
Disposal.................................... 20
11 Warranty .................................. 20
12 Declaration of Conformity ............ 20
GB
1

Symbols

Double insulation
Warning of general danger
Risk of electric shock
Use protective goggles!
Wear ear protection!
Use protective gloves!
Read the instructions
Not to be included in municipal refuse
Advice or tip
►
2

Technical data

Nominal voltage
Mains frequency
Power input
Adjustable revolutions
Tool diameter
Weight
Protection class
3

Prescribed usage

The machine works on the principle of an
angle grinder but uses also special tools
for milling and grinding, e.g. of concrete
and plaster.
The machine is intended for removal of
paint coats, plasters, residues of wall tile
and carpet adhesives mainly from rigid sur-
faces. In addition, the machine can be used
for roughing of fl at concrete surfaces and
for milling of lining work transitions.
The user proper is responsible for improper
usage.
230 V ~
50 / 60 Hz
1100 W
2000 - 5900 min
-1
80 mm
3.2 kg
II /
13