Integrated Descaling Programme - Melita Caffeo Solo Manual De Instrucciones

Cleaning phase 2 (
When illuminates, proceed as follows:
• Fill the water reservoir with tap water up
to the max. mark.
• Press outlet 2 all the way down.
• Press the button to continue with
the cleaning programme (takes about 5
minutes).
Cleaning phase 3 (
When illuminates, proceed as follows:
• Empty the drip tray and coffee grounds
container.
• Insert the drip tray without the coffee
grounds container
• Place the coffee grounds container
under outlet 2.
Cleaning phase 4 (
bean is fl ashing):
• The cleaning programme will be
continued again and takes about 5
minutes.
When illuminates, proceed as follows:
• Empty the drip tray and coffee grounds
container and insert them in the
appliance as usual.
The cleaning programme is fi nished.
BA_Solo_042015.indd 21 BA_Solo_042015.indd 21

Integrated descaling programme

):
The descaling agent can cause skin
irritations
Comply with the safety instructions
and the dosing information specifi ed
on the descaling agent packaging.
The integrated descaling programme
):
(takes about 30 minutes) removes lime
residues inside the appliance. The symbol
for descaling
process.
The descaling programme should be
performed every 3 months, however, at
the latest when
the water hardness", page 19).
Only use Melitta
, the middle
• Switch off the appliance.
• Remove the water fi lter if necessary
(„Water hardness and fi lter", page 18).
• Press the
simultaneously for approx. 3 seconds.
• Empty and insert the drip tray.
illuminates.
• Completely empty the water reservoir.
• Add the descaling agent to the water
reservoir according to the instructions on
the packaging.
• Insert the water reservoir.
• Press the
descaling programme (takes about 15
minutes).
Warning!
fl ashes during the entire
illuminates („Setting
® ANTI CALC.
and buttons
fl ashes, illuminates.
button to start the
21
20.04.2015 21:30:46 20.04.2015 21:30:46