Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Babyviewer 4500
– The volume of the reproduced sound is indicated by the volume LED's
The higher the volume, the more LED's are on.
– If no connection is established, the out of range icon is displayed and a beep is audible.
10.3 Out of range indication
The maximum range between the parent- and baby unit is 300 meter in open area. Different factors, such as bricks
and plaster walls, will reduce the range. Moreover, reinforced concrete floors will influence the range tremendously.
In a residence, normal operating range is up to 50 meters and 2 floors.
– If the connection is interrupted, the out of range icon is displayed and a beep is audible.
– Reduce the distance between the parent and baby units until a new connection is established.
10.4 Setting the reproduction volume of the parent unit
There are 5 volume levels.
– Press button
16
– Press button
17
10.5 Setting the parent unit display brightness
When the display in on.
– Press the menu button
– Press the up
16
– Press the menu button
– After 10 seconds the parent unit will switch back to monitor mode.
10.6 Temperature indication
When the display is on, the baby's room temperature is displayed in the right lower corner.
To set the temperature unit:
– Press the menu button
– Press the up
16
temperature indication off.
– Press the menu button
– After 10 seconds the parent unit will switch back to monitor mode.
10.7 Talking with your baby
You can use the parent unit to talk with your baby.
•
Allow your baby to get used to the talk function before you use it in practice.
– Press the Talk button
– Hold the parent unit vertical with the microphone approximately 10 cm from your mouth, and speak into
the microphone.
– Release button
PTT
PTT
10.8 Playing a lullaby
There are 5 pre-programmed lullabies that you can play on the baby unit.
– To play the currently selected lullaby or stop playback, press the play button
– To select a different lullaby, repeatedly press the lullaby button
The lullaby icon will display the selected lullaby (1 to 5). If no number is displayed, next to the lullaby icon,
all songs will be played successively.
When the lullaby starts playing, you have 10 seconds to set the volume of the lullaby.
– Press the up button
•
10 seconds after starting or selecting the lullaby, the parent unit will return to monitor mode.
The up button
parent unit.
•
To set the volume of the lullaby in monitor mode, switch the lullaby off and on using the
button
to increase the volume.
to decrease the volume.
once. The Brightness icon is displayed.
23
or down button
to select the desired brightness (5 steps).
17
to confirm.
23
twice. The temperature icon is displayed.
23
or down button
to °C (Celsius), °F (Fahrenheit) or "OFF", to switch the
17
to confirm.
23
on the parent unit and hold it pressed.
24
PTT
PTT
when you have finished talking.
24
to increase the volume or the down button
16
and down button
16
first before selecting the volume.
18
at the top of the parent unit.
14
until the desired lullaby is selected.
19
to decrease the volume.
17
can than only be used to set the volume of the
17
on the baby unit.
18
7
Publicidad
Tabla de contenido
