Assembly Transport Cart; Emptying And Servicing - Gloria 410 T Instrucciones De Uso

See separate sheet 976 559 (Optional
Accessories and Nozzle Table)**

Assembly transport cart*

Mounting the axle
23
Fig.
● 1. Insert transport cart axle in case part.
The axle noses must be aligned with
the notches on the case part so that
the axle can be inserted.
2. Once the axle noses are inserted, the
axle must be rotated through 90°.
3. Now push the axle through to the
stop on the opposite side.
4. Rotate the axle again through 90°.
5. Now push the axle so far that the
noses on the left and right sides sit in
the notches of the case part.
Mounting the wheels
24
Fig.
● Push the wheels onto the axle on the left
and right sides. Place a snap-on fastener
on the axle end and push it onto the axle
using a plastic hammer. The wheels
must be able to turn freely.
Note! Snap-on fasteners can only be re-
moved by destroying them
Mounting the handle
25
Fig.
● Attach the upper curved rod and screw
together with the straight rod piece to
form a complete handle.
26
Fig.
● 1. Position the handle on the pin of the
case part. Attention! The handle
must point backwards as illustrated.
2. Now push the handle down to the
stop on the pin, the detents must en-
gage in both holes.
Position and mount the spraying unit
27
Fig.
● 1. Position the spraying unit as illus-
trated.
2. Screw spraying unit to handle.
* Available as an accessory or included
in the scope of delivery in units with
compressor connections.

Emptying and Servicing

● Operate the pressure relief valve
(red button) until the unit is no
longer under pressure.
● Open the pump carefully, at first only a
few turns to the left, to allow any com
pressed air still in the tank to escape.
Only then should the pump be un-
screwed completely and removed from
the tank.
● Clean the unit thoroughly with water after
each use, rinsing out several times, and
leave open to dry, if possible hanging up
with the opening pointing down.
● Store the unit in a depressurised condition.
● To clean the filter tube in the quick close
valve:
31