Soehnle SYSTO MONITOR CONNECT 300 Instrucciones De Manejo página 167

Table 2
Guidance and manufacturer's declaration – electromagnetic immunity
The device is intended for use in the electromagnetic environment specified below.
The customer or the user of the device should assure that it is used in such an environment.
Immunity test IEC 60601 test level Compliance level
Electrostatic ±8 kV contact
discharge (ESD) ±15 kV air
IEC 61000-4-2
Electrical fast power supply lines:
transient/burst ±2 kV
IEC 61000-4-4 input/output lines:
±1 kV
Surge line(s) to line(s):
IEC61000-4-5 ±1 kV
line(s) to earth:
±2 kV
100 kHz repetition
frequency
Voltage 0% 0.5 cycle
dips, short At 0°, 45°, 90°, 135°,
interruptions 180°, 225°, 270°
and voltage and 315°
variations on 0% 1 cycle
power supply and 70% 25/30 cycles
input lines Single phase: at 0
IEC 61000-4-11 0% 300 cycle
Power frequency 30 A/m
(50Hz/60Hz) 50Hz/60Hz
magnetic field
IEC 61000-4-8
NOTE: UT is the a.c. mains voltage prior to application of the test level.
±8 kV cont act
±15 kV air
power supply lines:
±2 kV
line(s) to line(s):
±1 kV
100 kHz repetition
frequency
0% 0.5 cycle
At 0°, 45°, 90°, 135°,
180°, 225°, 270°
and 315°
0% 1 cycle
and 70% 25/30 cycles
Single phase: at 0
0% 300 cycle
30 A/m
50Hz/60Hz
EMC GUIDANCE
Electromagnetic
environment - guidance
Floors should be wood, concrete
or ceramic tile. If floors are
covered with synthetic material,
the relative humidity should be
at least 30%.
Mains power quality should be
that of a typical commercial or
hospital environment.
Mains power quality should be
that of a typical commercial or
hospital environment.
Mains power quality should be
that of a typical commercial or
hospital environment.
Power frequency magnetic
fields should be at levels charac-
teristic of a typical location in a
typical commercial or hospital
environment.
165