Customer Service; Troubleshooting - Soehnle SYSTO MONITOR CONNECT 300 Instrucciones De Manejo

PROBLEM
Display does not
light up
Display is difficult to
see or slow
E 01 is displayed
E 02 is displayed
E 03 is displayed
E 04 is displayed
EExx is displayed.
is
displayed
"Out" is displayed
POSSIBLE CAUSE
Batteries are empty
Batteries are not
inserted correctly.
The DC adapter is not
inserted correctly.
Battery charge is
too low.
The cuff is too tight or
too loose.
The blood pressure
monitor displays
movement during the
measurement.
No pulse was detected
during measurement.
A precise measurement
could not be performed.
A "calibration error" oc-
curred. (XX can indicate
a digital signal, e.g. 01,
02 etc.)
Low battery charge
Outside of the measure-
ment range

TROUBLESHOOTING

RESOLUTION
Replace batteries
Insert batteries correctly.
Insert the DC adapter correctly.
Replace batteries
Reposition cuff and repeat measurement
Movements may affect the measurement.
Relax for a moment and repeat the
measurement.
Remove the clothing from your arm and
repeat the measurement.
Relax for a moment and repeat the
measurement.
Repeat the measurement. If the problem
occurs again please contact your seller or our
customer service for further assistance.
The charge status of the battery is too low;
batteries must be replaced.
Relax for a moment. Reposition the cuff and
repeat the measurement. If the problem
occurs again please contact your doctor.
EN
35