HumanTechnik signolux Instrucciones De Servicio página 13

12 / 24 hour mode
The time can be displayed in a 12- or
24 hour mode.
The adjustment is made with the
»24h/12h« switch on the reverse side
of the alarm clock.
Power cut backup
The battery compartment can hold 4
batteries of size AAA (not included).
In the event of a power cut, these
guarantee the continuation of the set
time and the display of the signolux
signals.
Please note: During a power cut, the
time display and the flash are not ac-
tive as the power consumption is too
high for the backup batteries!
Setting and programming
Programming signals and assign-
ment to the symbols:
Up to 8 transmitters (e.g. the door-
bell push-button) can be assigned to
each symbol.
This assignment can be adapted by
programming.
Kindly keep in mind that a transmitter
can only be programmed if it is not yet
known in the memory of the signolux
receiver. If required, you first might
have to delete the transmitter from the
memory.
a) Keep the function button »
pressed for some time. The symbols
flash in sequence. Release the but-
ton as soon as you see the desired
symbol.
b) Now trigger the signal using your
transmitter (e.g. operate the doorbell
pushbutton).
c) Wait for about 20 seconds and test
the function.
Deleting transmitters from the re-
ceiver memory
Do the following if you want to remove
transmitter from the memory:
a) Keep the function button »
pressed for some time. The symbols
flash in sequence. Let go of the but-
ton as soon as you see the desired
symbol.
b) Now press the function button »
and the melody button » « until all
symbols briefly light up.
Please note that this will remove all
assigned transmitters from the se-
lected symbol.
•
«
•
«
•
«
English 13