Safety Precautions - Chauvin Arnoux C.A 5011 Manual De Instrucciones

Ocultar thumbs Ver también para C.A 5011:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Deutsch .......................................................................... 24
Italiano ............................................................................ 35
Español .......................................................................... 46
Thank you for purchasing a C.A 5011 Multimeter.
For best results from your instrument:
„ read this user manual carefully,
„ comply with the precautions for use.
WARNING, DANGER ! The operator should refer to this user's
manual whenever this danger symbol appears.
Equipment protected by double insulation.
The CE marking indicates conformity with European directives, in
particular LVD and EMC.
The rubbish bin with a line through it indicates that, in the European
Union, the product must undergo selective disposal in compliance with
Directive WEEE 2002/96/EC. This equipment must not be treated as
household waste.
„ Never use on networks at a voltage above 1000 V in relation to the earth. This
multimeter of overvoltage category III, satisfies the severe requirements of reliability
and availability corresponding to industrial and domestic permanent installations
(c.f. IEC 664-1).
„ Use indoors in environments of degree of pollution at most equal to 2 (c.f. IEC
664-1), of temperature from 0 to +55°C and of relative humidity from 20 to 90 %.
„ Respect the value and the type of fuses or there is a risk of damage to the
instrument and cancellation of the warranty.
- Fuse 1 A HBC (6 x 32 mm)
- Fuse 10 A HBC (6 x 32 mm)
„ Use accessories in conformity with safety standards (NF EN 61010-2-031) of
minimum voltage 1000 V and overvoltage category III.
„ Before any measurement, check the leads and the switch are in the correct
position. When the order of magnitude of a measurement is not known, place
the selector switch on the highest range then lower progressively, if necessary,
to the appropriate range.
„ Never measure resistances on a live circuit.
„ For current measurements (without current clamp), switch off the power supply of
the circuit before connecting or disconnecting your multimeter.
„ To open the battery compartment, the leads must be disconnected.
„ Never connect to the circuit to be measured if the battery compartment is not
correctly closed.

SAFETY PRECAUTIONS

13

Publicidad

Tabla de contenido
loading

Tabla de contenido