Service And Maintenance - Festool FSK 250 Manual De Instrucciones

7.2 Sawing
WARNING
Risk of injury
Exposed rotating saw blade
► Keep your hands away from the cutting
area and the saw blade.
► Do not reach under the workpiece.
► Never hold a workpiece in your hand or
support it with your leg.
► The cross cutting guide rail must be
attached on the workpiece with a fastening
clamp [3-1] or similar clamping tool before
sawing. This prevents the saw accidentally
being lifted from the workpiece and the
saw blade therefore being exposed.
If the saw or the pendulum guard fails to return
to its initial position (parked position), stop the
sawing process and remove the battery pack or
disconnect the mains plug from the socket.
Check whether the tool is functioning properly
and remove any trapped wood splinters.
The parked position and working position of the
saw are marked on the cross cutting guide rail
as follows:
Parked position
Closed pendulum guard
Working position
Open pendulum guard
Sawing process
► Place the adjustable stop [2-1] and the fixed
stop against the workpiece and position
cross cutting guide rail.
► Attach the cross cutting guide rail to the
workpiece with a fastening clamp [3-1] or
similar clamping tool.
► Switch on saw.
► Push saw in sawing direction.
Pendulum guard opens.
► Saw section.
► Switch off the saw after sawing procedure.
► Bring the saw back to the parked position.
The pendulum guard closes.
► Remove the fastening clamp.
► Lift the cross cutting guide rail from work­
piece.
Placing down the saw
WARNING
Risk of injury when placing down the saw
with the saw blade exposed
► Never place down any saws with exposed
saw blades
► Bring the saw back to the parked position
before placing it down.
8

Service and maintenance

Customer service and repairs must
only be carried out by the manufac­
turer or service workshops. Find the
nearest address at:
www.festool.com/service
Always use original Festool spare
EKAT
4
parts. Order no. at:
www.festool.com/service
5
3
2
1
Cleaning the machine regularly, espe­
cially the adjusting devices and guides, is
an important safety factor.
Observe the following information:
► The pendulum guard must always be able to
move freely and close independently.
Always keep the area around the pendulum
guard clean. Clean dust and chippings by
blowing out with compressed air or using a
brush.
English
11