General Safety Warnings; Other Risks - Festool FSK 250 Manual De Instrucciones

Contents
1 Symbols......................................................... 9
2 Safety warnings.............................................9
3 Intended use................................................10
4 Technical data............................................. 10
5 Commissioning........................................... 10
6 Assembly..................................................... 10
7 Working with the power tool....................... 10
8 Service and maintenance............................11
1 Symbols
Warning of general danger
Read the operating manual and safety
instructions.
Tip or advice
Handling instruction
Risk of pinching fingers and hands!
Danger area! Keep hands away!
Cutting injury hazard caused by
exposed saw blade
Do not place down any saws with
exposed saw blades
Pendulum guard open
Pendulum guard closed
Parked position
Place down saws with closed
pendulum guards only
Use the fastening clamp supplied to
secure the cross cutting guide rail to
the workpiece.
2 Safety warnings
2.1

General safety warnings

Warning! Read all safety warnings and
instructions which have been supplied
with the mounting device or the portable
circular saw. Failure to observe the information
and safety warnings may lead to electric
shocks, fires and/or serious injuries.
Keep all safety warnings and instructions for
future reference.
The term "power tool" used in the safety warn­
ings refers to mains-powered power tools (with
power cable) and battery-powered power tools
(without power cable).
Disconnect the plug from the socket
–
and/or remove the battery before
adjusting the tool settings or changing
accessory parts. Some accidents are
caused by power tools starting accidentally.
– Secure the power tool safely on the
mounting device before using it. If the
power tool slips on the mounting device,
you may lose control of the tool.
Place the mounting device on a solid, even
–
and horizontal surface. If the mounting
device slides or wobbles, it may not be
possible to control the power tool safely
and reliably.
– Check the function of the pendulum guard
prior to use and do not use the power tool if
it does not function correctly.
– When working, always hold the power tool
with both hands on the handles . This
reduces the risk of injury and is a prerequi­
site for precise work.
Before use, always check the function of
–
the cross cutting guide rail and ensure
that all warning notices are legible and
attached to the cross cutting guide rail in
as-delivered condition. If the warning
notices are missing, non-compliance with
the instructions can cause a higher risk of
injury.
2.2

Other risks

In spite of compliance with all relevant design
regulations, dangers may still present them­
selves when the machine is operated, e.g.:
– Touching the part of the saw blade that
protrudes below the cross cutting guide
rail:
– When approaching the workpiece,
– During cutting,
English
9