Display Settings - Kenwood DPX302U Manual De Instrucciones

AUDIO SETTINGS
PRESET EQ DRIVE EQ/ TOP40/ POWERFUL/ ROCK/ POPS/ EASY/ JAZZ/
NATURAL/ USER: Selects a preset equalizer suitable to the music
genre. (Select [USER] to use the settings made in [EQ PRO].)
[DRIVE EQ] is a preset equalizer that reduces noise outside the car or
running noise of the tyres.
BASS BOOST LEVEL1/ LEVEL2/ LEVEL3: Selects your preferred bass boost level. ;
OFF: Cancels.
LOUDNESS LEVEL1/ LEVEL2: Selects your preferred low and high frequencies
boost to produce a well-balanced sound at a low volume level. ;
OFF: Cancels.
SUBWOOFER SET ON: Turns on the subwoofer output. ; OFF: Cancels.
LPF SUBWOOFER THROUGH: All signals are sent to the subwoofer. ; 85HZ/ 120HZ/
160HZ: Audio signals with frequencies lower than 85 Hz/ 120 Hz/
160 Hz are sent to the subwoofer.
SUB-W PHASE REVERSE (180°)/ NORMAL (0°): Selects the phase of the subwoofer
output to be in line with the speaker output for optimum performance.
(Selectable only if a setting other than [THROUGH] is selected for
[LPF SUBWOOFER].)
FADER R15 to F15 (0): Adjusts the rear and front speaker output balance.
BALANCE L15 to R15 (0): Adjusts the left and right speaker output balance.
VOLUME OFFSET For AUX: –8 to +8 (0) ; For other sources: –8 to 0: Preset the initial
volume level of each source. (Before adjustment, select the source you
want to adjust.)
SOUND RECNSTR ON: Creates realistic sound by compensating the high-frequency
(Sound components and restoring the rise-time of the waveform that are lost
reconstruction) in audio data compression. ; OFF: Cancels.
• [SUB-W LEVEL]/ [SUBWOOFER SET]/ [LPF SUBWOOFER]/ [SUB-W PHASE] is
selectable only if [SWITCH PREOUT] is set to [SUBWOOFER]. ( 4)
• [SUB-W LEVEL]/ [LPF SUBWOOFER]/ [SUB-W PHASE] is selectable only if
[SUBWOOFER SET] is set to [ON].
16

DISPLAY SETTINGS

Set the dimmer
Press and hold DISP (DIMMER) to turn on or off the dimmer.
• If you have set [DIMMER TIME], it will be canceled once you press and
hold this button.
Other settings
1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select [DISPLAY], then press the knob.
3
Turn the volume knob to select an item ( 17), then press the knob.
4 3
Repeat step until the desired item is selected/activated or follow
the instructions stated on the selected item.
5
Press and hold to exit.
To return to the previous setting item, press .