Installation; Basic Procedure - Kenwood DPX302U Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Warning
• The unit can only be used with a 12 V DC power supply, negative
ground.
• Disconnect the battery's negative terminal before wiring and
mounting.
• Do not connect Battery wire (yellow) and Ignition wire (red) to the
car chassis or Ground wire (black) to prevent a short circuit.
• Insulate unconnected wires with vinyl tape to prevent a short circuit.
• Be sure to ground this unit to the car's chassis again after

installation.

Caution
• For safety's sake, leave wiring and mounting to professionals.
Consult the car audio dealer.
• Install this unit in the console of your vehicle. Do not touch the
metal parts of this unit during and shortly after use of the unit.
Metal parts such as the heat sink and enclosure become hot.
• Do not connect the [ wires of speakers to the car chassis or Ground
wire (black), or connect them in parallel.
• Mount the unit at an angle of less than 30º.
• If your vehicle wiring harness does not have the ignition terminal,
connect Ignition wire (red) to the terminal on the vehicle's fuse box
which provides 12 V DC power supply and is turned on and off by
the ignition key.
• Keep all cables away from heat dissipate metal parts.
• After the unit is installed, check whether the brake lamps, blinkers,
wipers, etc. on the car are working properly.
• If the fuse blows, first make sure the wires are not touching car's
chassis, then replace the old fuse with one that has the same rating.

Basic procedure

1
Remove the key from the ignition switch, then
disconnect the [ terminal of the car battery.
2
Connect the wires properly.
See Wiring connection. (  23)
3
Install the unit to your car.
See Installing the unit (in-dash mounting).
4
Connect the [ terminal of the car battery.
5
Reset the unit. (  3)
22
Installing the unit (in-dash mounting)
Do the required wiring.
(  23)
Dashboard of your car
When installing without the mounting sleeve
1
Remove the mounting sleeve and trim
plate from the unit.
2
Align the holes in the unit (on both sides)
with the vehicle mounting bracket and
secure the unit with screws (commercially
available).
Use only the specified screws.
Using wrong screws might damage
the unit.
Part list for installation
(A) Mounting sleeve
(B) Trim plate
Bend the appropriate tabs to hold
the mounting sleeve firmly in place.
How to remove the unit
Insert the extraction keys deeply
into the slots on each side, then
follow the arrows as shown on
below.
(C) Wiring harness
(D) Extraction key

Publicidad

Tabla de contenido
loading

Tabla de contenido