General Guidelines - HQ-Power VDPL300LS Manual Del Usuario

3.

General Guidelines

Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
This device is a lighting effect for creating decorative effects. This product is only allowed to be
•
operated with an alternating voltage of 230 V, 50 Hz and was designed for indoor use only.
This device is designed for professional use, e.g. on stages, in discotheques, theatres etc.
•
Lighting effects are not designed for permanent operation. Consistent operation breaks will ensure that
•
the device will serve you for a long time without defects.
• Do not shake the device. Avoid brute force when installing or operating the device.
When choosing the installation location, please make sure that the device is not exposed to extreme
•
heat, moisture or dust. There should not be any cables lying around.
This device must never be operated or stockpiled in surroundings where splash water, rain, moisture or
•
fog may harm the device. Moisture or very high humidity can reduce the insulation and lead to fatal
electrical shocks. When using smoke machines, make sure that the device is never exposed to the
direct smoke jet and is installed in a distance of 0.5 meters between smoke machine and device. The
room must only be saturated with an amount of smoke that the visibility will always be more than 10
meters.
• The ambient temperature must always be between -5° C and +45° C. Keep away from direct insulation
(particularly in cars) and heaters.
The relative humidity must not exceed 50 % with an ambient temperature of 45° C. This device must
•
only be operated in an altitude between -20 and 2000 m over NN.
Always disconnect the device during thunderstorms.
•
• This device is only allowed for an installation via the mounting bracket. In order to safeguard sufficient
ventilation, leave 50 cm of free space around the device.
The housing must never touch surrounding surfaces or objects.
•
Operate the device only after having become familiarized with its functions. Do not permit operation by
•
persons not qualified for operating the device. Most damages are the result of unprofessional operation.
Never use solvents or aggressive detergents in order to clean the device. Rather use a soft and damp
•
cloth.
• Use the original packaging if the device is to be transported. Make sure that you pack the device in the
original state.
Never remove the serial barcode from the device as this would make the guarantee void.
•
If this device will be operated in any way different to the one described in this manual, the product may
•
suffer damages and the guarantee becomes void. Furthermore, any other operation may lead to
dangers like short- circuit, burns, electric shock, crash etc.
4. Features
a real eye catcher: 5 LED lenses in pentagon form
•
• works in stand-alone mode, master/slave, sound control via built-in microphone or DMX controlled
• DMX channels selectable in 2- or 3-channel mode
• easy menu setting via LED display with 4 buttons
equipped with 160 bright 5mm LEDs
•
linkable power connection, connect up to 8 units
•
5. Installation
Consider the EN 60598-2-17and the respective national standards during the installation. The
•
installation must only be carried out by an authorized dealer.
Make sure the installation can hold 10 times the weight for 1 hour without any harming deformation.
•
• The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch
net. This secondary safety attachment must be constructed in a way that no part of the installation can
fall down if the main attachment fails.
• When rigging, derigging or servicing the device staying in the area below the installation place, on
bridges, under high working places and other endangered areas is forbidden.
The device should be installed outside areas where persons may walk by or be seated.
•
IMPORTANT. OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to)
•
calculating working load limits, installation material being used, and periodic safety inspection of all
installation material and the device. If you lack these qualifications, do not attempt the installation
yourself, but instead use a professional structural rigger. Improper installation can result in bodily
injury and or damage to property.
V. 02 – 22/08/2014
VDPL300LS
4 ©Velleman nv