GUTMANN Amplia 5300 Instrucciones De Uso página 86

en
1. INTRODUCTION 1. VORBEMERKUNGEN
Warning
Mounting, connection, commissioning and repairs must be carried out by specialized
personnel. This personnel is able to determine the appropriate mounting flange and
the hood discharge. The mounting flange has to be adapted to the weight of the hood
and the load capacity of the mounting wall. Observe the values shown on the inlays
supplied. Depending on the type of the mounting wall, they have the following values:
Ø 10 mm inlay, concrete wall B25 9.4 KN, brick wall Z20 5.2 KN, solid brick wall
KSV20 4.8 KN. For other walls types, in order to guarantee a secure mounting of the
hood, it is advisable to consult construction work specialists, such as a static con-
struction specialist or an architect.
Risk of injury!
For reasons related to the body hood production, sharp angles may be present. It is
therefore necessary to wear gloves during assembly.
Electric shock risk!
The mains voltage must correspond to the one indicated on the plate located in the
filter area in the inner part of the hood. Connect the hood only to a properly installed
safety socket. The socket, after installation, should be easily accessible, so that you
can disconnect the hood from the current, in case of emergency. For fixed connec-
tions (e.g. if you don't have a proper outlet), the hood can be connected to the power
line only by a qualified electrician. In case of fixed connection, the hood must be fitted
to a single circuit with a circuit breaker. They can be circuit breakers like switches with
a contact separation of at least 3 mm and pole circuit breakers, for example switches
and relays. Before drilling the holes for mounting, make sure that electric lines cannot
be damage. The connection to the mains must be made in such a way to connect the
hood easily to the power outlet. Locally applicable regulations must always be com-
plied with.
Aspiration (for recirculation mode)
The hood discharge cannot be conveyed to a fireplace used for unloading of fuels
(e.g. gas). Always observe local regulations for air discharge. The discharge trace
18
Bedrijfsinstr
ucties
I n st al l at i e-
instructies