BTI PROFILINE 37629 Instrucciones De Manejo página 58

E N G L I S H
5. When drilling deep holes, if the hammer speed starts
to drop off, pull the bit partially out of the hole with
tool stil running to help clear debris from the hole.
NOTE: A smooth, even fl ow of dust from the hole
indicates proper drilling rate.
Screwdriver Operation (fi g. 6)
1. Select the desired speed/torque range using the dual
range gear selector to match the speed and torque
of the planned operation.
2. Turn the torque adjustment collar to the desired
position. Lower numbers indicate lower torque settings;
higher numbers indicate higher torque settings.
3. Insert the desired fastener accessory into the chuck
as you would any drill bit.
4. Make some practice runs in scrap or on unseen areas
to determine the proper position of the clutch collar.
5. Always start with lower torque settings, then advance
to higher torque settings to avoid damage to the
workpiece or fastener.
MAINTENANCE
Your BTI power tool has been designed to operate over
a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper
tool care and regular cleaning.
WARNING: To reduce the risk of injury,
turn unit off and disconnect tool from
power source before installing and
removing accessories, before making
any adjustments or removing/installing
attachments or accessories.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of the main
housing with dry air as often as dirt is seen
collecting in and around the air vents. Wear
approved eye protection and approved dust
mask when performing this procedure.
WARNING: Never use solvents or other
harsh chemicals for cleaning the non-
metallic parts of the tool. These chemicals
may weaken the materials used in these
parts. Use a cloth dampened only with
water and mild soap. Never let any liquid
get inside the tool; never immerse any part
of the tool into a liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect the
charger from the AC outlet before cleaning.
Dirt and grease may be removed from the
exterior of the charger using a cloth or soft
non-metallic brush. Do not use water or any
cleaning solutions.
Optional accessories
WARNING: Since accessories, other
than those offered by DEWALT, have
not been tested with this product, use of
such accessories with this tool could be
hazardous. To reduce the risk of injury,
only DEWALT, recommended accessories
should be used with this product.
Consult your dealer for further information on the
appropriate accessories.
Protecting the Environment
Separate collection. This product must not be
disposed of with normal household waste.
Should you fi nd one day that your BTI product needs
replacement, or if it is of no further use to you, do not
dispose of it with household waste. Make this product
available for separate collection.
Separate collection of used products and
packaging allows materials to be recycled and
used again. Re-use of recycled materials helps
prevent environmental pollution and reduces the
demand for raw materials.
Local regulations may provide for separate collection of
electrical products from the household, at municipal waste
sites or by the retailer when you purchase a new product.
BTI provides a facility for the collection and recycling of BTI
products once they have reached the end of their working
life. To take advantage of this service please return your
product to any authorised repair agent who will collect
them on our behalf.
You can check the location of your nearest authorised
repair agent by contacting your local BTI offi ce at the
address indicated in this manual.
58