SPARKY HeavyDuty VC 1530SP Manual De Instrucciones página 14

tRoUblEsHootING
fault
Motor does not start
Motor does not run in
automatic mode
Reduced suction
power
The alarm sounds
(reduced suction
power)
(Models
VCM 1530SP,
VCM 1530SA only)
No suction power
during wet cleaning
Voltage fluctuations
12
EN
probable cause
A fuse of the mains socket has
blown.
The overload protection switch has
tripped.
The motor is faulty.
The power tool/pneumatic tool is
defective or not connected properly.
The power rating of the power tool
is too low.
The suction power selected with suc-
tion power control is too low.
Clogged suction hose/nozzle.
The tank, disposal bag or filter bag
is full.
The filter element is clogged.
The seal between tank and upper
section of vacuum cleaner is faulty
or missing.
The cleaning system is defective.
The suction power selected with
switch (4) is too low.
The hose diameter does not corre-
spond to the switch (12) position.
Clogged suction hose/nozzle.
The tank, disposal bag or filter bag
is full/
The filter element is clogged.
The seal between the tank and the
upper section is faulty or missing.
The cleaning mechanism is faulty.
The tank is full.
Impedance of power supply is too
high.
VC 1530SP • VC 1530SA • VCM 1530SP • VCM 1530SA
Remedy
Connect the mains fuse.
Switch off the vacuum cleaner and allow it to cool for
approx. 5 minutes. If the cleaner cannot be started
again, contact a SPARKY service centre.
Have the motor changed by a SPARKY service
centre.
Check that the power tool is functioning or that the
plug is inserted correctly into the built-in socket.
Note that minimum power rating P>40W.
Set suction power in accordance with section „Suc-
tion power control".
Clean hose/nozzle
Refer to "Emptying the tank" or "Replacing the
disposal bag",
Refer to "Cleaning the filter" or "Replacing the PET
cartridge filter".
Replace the seal.
Contact a SPARKY service centre.
Increase the suction power. Refer to section "Suc-
tion power control".
Set the correct switch position.
Clean the suction hoze/nozzle.
Refer to sections "Emptying the tank", "Replacing
the disposal bag", "Replacing the fleece filter bag".
Refer to sections "Cleaning the filter" and "Replacing
the filter"
Replace the seal.
Contact a SPARKY service centre.
Switch off the vacuum cleaner. Empty the tank.
Connect the vacuum cleaner to another socket
closer to the fuse box. Voltage fluctuations over 7%
should not occur if the impedance at the transfer
point is ≤ 0.15 Ω.